From: "Tim" <tjp314@pacbell.net>
Date: January 11, 2007 4:54:29 PM MST
To: Astro_IIDC@yahoogroups.com
Subject: connections for long exposures with Pt Greys
Hi Milton:
If you have the chance, could you look up which pins need to be
connected on the back of the Pt Grey cameras to enable exposures
beyond half a second?
For the short term, I simply swapped the connector I'd already done
this to from my Flea to my Flea2. The Flea didn't have any wires in
the connector, so I made one with a wire tie I had laying around, and
so it's a really small thingy all buttoned up in the connector. If I
take it apart, I might not see where I had the wire connected.
Thankfully, the Flea2's connector has 3 inches or so of wires coming
out of it, so simply twisting the right ones together ought to do the
trick, I figure, so long as I do the right ones.
So far, the couple nights I tried the fleas out on the Tak mounts,
with the GPUSB plugged in, I was able to get the mount control in
Astro IIDC to link up with the mount famously every time.
But my guiding wasn't too good, even with the guide speed on the mount
set to the slowest rates. I suspect that faintness of the guide star
might have been a factor, but I don't know for sure. I should have
tried guiding (without imaging) using the flea2 with the connector set
up for long exposures, I suppose. But my brain doesn't tend to think
of these obvious things when I'm tired and freezing my... Well, you
get the idea...
;o)
-Tim.